C6 LS2 Stage 2
C6 Stage 2 Up to 480 HP
1. THE VORTEX RAMMER COLD AIR SYSTEM C6 VETTE
BREATHLESS PERFORMANCE PRODUCTS- This vortex rammer kit replaces the restrictive stock air box assembly. Look closely at the filter and note that this is not the K&N filter that everyone sells. This revolutionary air cleaner contains an internal vortex velocity stack. It obtains cool, pressurized air from the radiator cavity through your modified shroud. Air is forced through a sealed box, where in turn, it directly injects cold air into your intake. (Lowering Manifold Air Temperature by almost 30 Degrees)
Remember, cold air means more power. Our HP results have already shown up to 36HP and 38FT/LBS at the flywheel. Running at speed has give an additional up to 10 more Hp due to the air being forced in.. This is from the benefit of the pressurized air that is created at high speeds (which means there will be more h.p. at speeds over 35 MPH. 1/4 mile tests showed 3 MPH and .30
C6 auto test one showed 26 flywheel HP
C6 stick test two showed 21 flywheel HP
BPP's powerduct is made out of 100% pure Carbon Fiber
The power duct replaces the stock air bridge between throttle body and MAF. It increases the air flow to the motor by over thirty three percent.
The kits are available in CLEAR, BLACK and CARBON FIBER.
(Clear finish provides a visual access to your Filter and Radiator for service inspection.)
Note: Z06 model is available with factory MAF already installed.
2. Breathless Ported Throttle Body
Breathless Performance Products’ Ported & Flowed Throttle Body increases CFM flow to match your performance upgrades. Each unit is hand ported, Cleaned, then flowed to over 1000 CFM. A must once mods are done to your car. HP increase depending on mods range between 6-15 HP.
A core charge of $300 would be applied and would be refunded upon receipt of you stock unit.
3. C6 Corvette Magna Flow Cat Back Exhaust
This Magnaflow catback for your C-6 Corvette is just what you need for that extra power and great sound you have been looking for. This Magnaflow C-6 catback is a fully complete Corvette exhaust system with Tru-X X-pipe. Other Magnaflow exhaust systems we sell for the Corvette C6 are the X-pipe or axle-back individually. With the full exhaust system, you will see the best results.
An exhaust system gives you the most bang for your buck. It is the least expensive way to gain the most power. Magnaflow have logged gains of 13 horsepower and 11 lbs of torque on the dyno with this system. Do yourself a favor and invest in this exhaust system before any other performance upgrades.
Crafted from stainless steel
Polished, rolled edge tips
2.5" SS tubing
4.0" rolled/slash/p-SS tips
All Magnaflow Products come with full installation instructions and necessary hardware, as well as a full Lifetime Warranty!
4. 160 Degree Thermostat
5. 2005 & Up Corvette 8.5 Spark Plug Wires
MSD 8.5 Super Conductor spark plug wires.
* 40-50 ohms per foot of resistance
*High EMI suppression abilities
* Tough silicone/synthetic sleeve
* Durable, extra thick plug boots
* Dual Crimp terminals grip the wire and conductor
6. NGK Performance Spark Plugs
Stop playing around with spark plugs that feature fine wire electrodes, split electrodes, ring electrodes, multiple electrodes, platinum electrodes, copper electrodes or gold electrodes and get serious. One Step cooler for plug range for the ultimate performance
- Lowers ignition system voltage requirements
- Greater ignitability and performance over conventional spark plugs
- “Trivalent Metal Plating” has superior anti-corrosion and anti-seizing properties
- Increased fuel economy and lower emissions
- Highly durable against electrical and chemical wear
- Good performance spark plug
Sold as a set of 8
PART #700-020-LS3 $2500.99